SMATRICS customers are obliged to observe the parking and (road) traffic rules and to leave the space at the public charging station once the vehicle is fully charged in a reasonable time, so that other customers can also charge their cars. The electricity consumption must not exceed the value according to manufacturer specifications (depending on the respective contract vehicle) by more than 50%.
The increasing electrification of vehicles is important to reduce CO2 emissions as well as the dependency on oil. The number of electric cars in Austria is increasing month by month in a double digit percentage range. While there were 989 electric and plug-in vehicles on Austria´s roads in 2011, there were 7,614 cars at the end of 2015. The number of e-cars registrations has almost doubled in the first half of 2016 (in comparison to the first half of 2015) in Austria. More and more federal states in Austria offer subsidies to facilitate the transition from conventional combustion engines to electric cars.
Electromobility is the new form of individual mobility with cars, which obtains all (electric vehicles) or some (plug-in hybrid vehicles) of its energy from electricity.
We can successively make ourselves independent from fossil energy sources with electricity as an energy source. In this regard, SMATRICS offers the security of using 100% electricity from renewable energy sources. This allows almost CO2-free mobility, significantly reduces fine-particle and noise pollution and increases the quality of life.
SMATRICS EnBW, a joint subsidiary of EnBW Energie Baden-Württemberg AG and SMATRICS GmbH & Co. KG, will operate the largest Austria-wide charging network with 450 charging points at 250 charging locations - including around 250 fast charging points at around 100 fast charging locations - along freeways and in and around conurbations. The electricity at SMATRICS EnBW charging points comes 100% from renewable energies.
Nothing changes for customers of the public charging network with regard to the contractual relationship, charging card or tariffs; they will continue to be fully supported by the company SMATRICS.
With regard to an electric engine, maximum torque and thus full power is available over the entire speed range. This guarantees significantly better acceleration and the corresponding driving pleasure.
Type 1 AC current up to 32 amps and voltages up to 230 volts (AC: alternating current)
This single-phase charging plug is used exclusively for vehicle-side charging. The maximum charging capacity is 7.4 kW with 230 V alternating current. The connection was previously via an In Cable Control Box and Schuko socket outlet and the charging capacity was limited to max. 3 kW.
This plug will no longer used by European manufacturers as of 2017. However, it will then still be possible to charge a vehicle with a Type 1 plug with an adaptor cable.
Type 2 (“Mennekes”) AC currents (alternating current)
The plug connections can be used on the vehicle side and the infrastructure side. The Type 2 plug can be used to charge with 230V single-phase or 400V three-phase with charging capacities of 3.7 kW to 43.5 kW.
This plug type should be used as the standard plug by the European car manufacturers as of 2017.
Combined AC/DC plug type 2 for high-speed charging (DC: direct current)
The charging of electric vehicles with direct and alternating current is supported by the so-called “Combined AC/DC Charging System”. Only one single charging socket is required for charging with AC and DC due to the universal connector face of the vehicle-side inlet.
When charging with AC, the AC Connector Type 2 can be plugged into the inlet. The DC Connector Type 2 is plugged into the inlet for high-speed charging on the go with up to 200 A.
CHAdeMO DC (direct current)
This charging interface is based on direct current, it can charge with a voltage of 300 to 600 volts and with up to 62.5 kW. An electric car on empty can be charged to 80% of the battery capacity within 30 minutes.
This charging cable is fixed to the charging station.
Did you know that SMATRICS offers the optimal charging cable for your plug-in or electric car for each case? Further information can be found here.
Like all vehicles, electric cars must also undergo and pass dedicated safety tests (NCAP etc.) before they can be launched on the market. Therefore, there are no additional risks in comparison to conventional vehicles. For example, the high voltage elements lose their voltage in case of an accident, so that there is no risk for the user.
When charging, the use of incorrect connections or conventional plugs can lead to overheating or fire hazard. There is no risk of electric shock when charging at the SMATRICS charge points or wallboxes.
In general: Electrified vehicles can be charged safely in all weather conditions, and rain or snow are no problem.
At low speeds, electric cars could pose a problem for pedestrians and cyclists due to the lack of engine noise. However, the wind and road noise remains. Therefore, more attention must be paid to pedestrians when using electric vehicles in traffic. The behaviour of pedestrians and cyclists will adjust accordingly with the increase of electromobility in everyday traffic.
Household sockets are not constructed for continuous operation at full power and there not a safe charging option for cars. Furthermore charging times can be reduced with a professional charging unit (Wallbox). More information can be found here: Home-charging.
Costs and subsidies
As the mass production of electrically chargeable vehicles is only just starting, the costs on the manufacturer’s side are increased. The batteries are also very expensive due to the high quality, performance and safety. These costs will fall significantly in the coming years and thus positively affect the vehicle price.
In addition, electric vehicles are often fully equipped, thus they offer more comfort in comparison to conventional cars. For example, navigation systems and displays normally come as standard. The price is reduced by subsidies and the exemption from normal consumption tax (NoVA) and insurance tax.
SMATRICS product range
SMATRICS offers the following services for private individuals:
- Charging at public SMATRICS EnBW charging stations at along freeways and in congested areas as well as supermarkets, cinemas, petrol stations, P&R facilities, shopping centres
- Private charging stations (wallboxes) at home and charging cables
- Services such as 24 hour customer hotline, news ticker
- Mobile App with charging station finder, availability display and route planner
We need your data to be able to send you the bills and other exclusive offers.
Yes, it is possible with a SMATRICS wallbox. The wallbox is your personal charging station for fast and safe charging at home. SMATRICS provides you with everything you need from A to Z. install check up to introduction to your charging station. From installation and activation, to extra charging cables for all standard connections.
More information can be found here: Home charging
The new SMATRICS NET contracts (Single NET, Smart NET and Active NET) will be charged per use. Depending on your plan there is a basic fee and the chargin process is charged per minute. Click here for further informations.
Billing by kWh would mean that users park for too long and prevent other users from charging.
The charging station can only offer a maximum charging output. The output actually used for charging is determined by the vehicle itself based on various algorithms.
Billable charging procedures begin when you give the "Start" command at the charging station or in the app. The charging process itself can be ended in various ways: by using the "Stop" button on the station or in the app, or by pulling out the charging cable. Please note that the charging can also be stopped automatically by the car. We have no influence over this. We would also like to ask you to leave the charging station immediately after the charging procedure is completed so the next driver can also charge.
We need to make sure that our charging stations are not obstructed by parked cars and subsequent drivers can also charge.
Unfortunately this is not possible for technical reasons.
You will find a list of all charges in your personal account under "Last charges”, on our website or in the app.
You can choose your preferred means of payment. You can easily pay by direct debit or you can receive a monthly bill by post/Email.
change of tariff or cancellation of contract
Depending on the selected plan, there are certain minimum contract terms. After this period elapses, you can change to another plan. Service upgrades are possible at any time.
You will receive notification from us when your new tariff will be valid from.
No, this is billed on a pro rata basis.
For SinglePlus, SmartPlus and Active Plus NET contracts from June 1st 2020 onwards, no commitment period applies. There is an ordinary cancellation period of 2 weeks to the end of the month.
SMATRICS Customer Account
The SMATRICS user account shows your personal data, as well your charging history.
You can access your personal account via our website, where you can see all previous charges, under the menu item "last charges".
Charging can be started and terminated using the SMATRICS app instead of the SMATRICS customer card. It is not possible to combine both methods. If charging is started using the app, it must be terminated using the app.
Charging process and charging infrastructure
Yes, you can charge the battery at any time.
In the private sector, it is assumed that the wallbox is installed in a lockable area. With regard to public charging stations, the cable is locked on the charging station side during the charging process until the process is ended by the customer. Many electric vehicles also lock the charging cable on the vehicle side during the charging process.
No, only certified electric vehicles may be charged using the SMATRICS charge points and wallboxes.
There are various ways to end a charging process. This can also happen automatically sometimes, which can even be of advantage to you and you pay less.
No, if a charging session is started using the app/the charging card, it also must be terminated using your own app/your charging card.
SMATRICS High-speed charging stations are fitted with charging cables. All others vary, some have pre-fitted cables (typ2), others only have sockets (for type1 and type2 vehicles). In general we recommend that you always carrying your own charging cable. If a charging station has a socket or a cable is detailed in our web and app under charging network.
A current overview of the SMATRICS EnBW charging stations can be found on our website under the menu option “Charging Network ”. This overview is continuously updated with new charging stations. Furthermore, this information is also available on the SMATRICS mobile App for iOS and Android. Real-time information on the charging stations is available on the App (is the station free or occupied) and the App also has a routing feature that you can use to simply navigate to a selected station.
Charging via Smartphone
The charging is ended by clicking on the "Stop" button. After stopping the charging, the charge is displayed under "Last charges".
Please note: if the charge was started via the app, it must be ended with the app as well. It is not possible to combine the different connection methods (using the customer card or the app).
This service is only available for customers with a current tariff (available since 1 January 2016). Have you already created an account? Before logging in for the first time you need to create a SMATRICS account.
The email address used when registering must be the same one used for concluding the contract.
The charging time displayed in the app may differ from the actual charging time for system-related reasons. The actual duration is displayed under "Last charges".
This can happen if the charging point is occupied or if there is no data connection to the server.
If the charging point is free, please use your customer card.
Before the first login you have to create a SMATRICS account. The e-mail address used for registration must be the same as the one you used when signing up
This service is only available for customers who have signed a contract from 1.1.2016 onwards.
In this case please contact our service hotline +43 5 031 351 855. The hotline is able to stop the charging session for you.
The SMATRICS App can be downloaded for the iPhone in the Apple Store free of charge. The App is available to download for Android smartphones in the Play Store. Simply download and discover the charging possibilities.
You can learn more about the SMATRICS App here: SMATRICS mobile App for iOS and Android
If you are using the app for the first time, please create a SMATRICS account. Then you can log in with your email address and password.
After logging in you can select a SMATRICS EnBW station from the map view or from the list. In the detailed view of the charging station, select the chosen charging point and click on the "Charge" button. The charge can only be started if the chosen charging point is free and the connector symbol is green. If the vehicle is connected to the charging station, click on the "Start" button to launch the charging process.
Charging via the app only works for customers with valid contracts dated from 1 January 2016.
At roaming partners you can only start and end charging with a SMATRICS customer card. Starting and ending using the app is not possible. At www.smatrics.com you can select your chosen tariff and receive your personal customer card.